Joined
·
77 Posts
Dumb question; but I am finding this confusing.
During break-in I am supposed to be running 50:1 gas-oil mixture. Motor normally runs at 100:1 ratio.
Am I correct that with an oil injection system on the motor, that I should be pre-mixing oil in the fuel tank at 100:1 to get the correct mix?
Appreciate some guidance...thanks.
During break-in I am supposed to be running 50:1 gas-oil mixture. Motor normally runs at 100:1 ratio.
Am I correct that with an oil injection system on the motor, that I should be pre-mixing oil in the fuel tank at 100:1 to get the correct mix?
Appreciate some guidance...thanks.