Dedicated To The Smallest Of Skiffs banner

Trim and Tilt addition, couple of questions

2112 Views 3 Replies 2 Participants Last post by  daniel4616
I am looking to add trim and tilt, I have searched here and the options are CMC, Panther, and Bob's. The motor is 85lbs (15hp 2stroke) so the smaller options would be best: CMC PT35, or Panther 35.

MY question is- is one significantly better than the other? I researched a lot, and found people had good and bad for all of the mentioned. I am concerned with CMC after reading they do not offer replacement parts- just a $300 complete unit replacement. The Panther has NO hydraulics which appeals to me as they just use an electric screw drive. Bob's I dont know much about but I dislike that I would have to find a spot to mount the hydraulics (Althought the Action series is all in one, similar to CMC) and Bob's is the most expensive.

Is there really a difference in these units- I know they all do the same thing, but longevity, repair"ness", reliability are all things I am concerned about.

Let me know if you can.
1 - 2 of 2 Posts

· Registered
Joined
·
4,533 Posts
I REALLY like my BoB's

I will post a video

CMC HAS a Bad attitude !!! and their customer service SUCKS !!


BRB
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top