Dedicated To The Smallest Of Skiffs banner
1 - 4 of 4 Posts

·
I Love microskiff.com!
Joined
·
611 Posts
Discussion Starter · #1 ·
Looking through shop manual install seems simple enough.

Are there any gotchas I should watch for, or install tips you know of?

Thanks,
Jim
 

·
Cert. Yamaha technician
Joined
·
4,330 Posts
Its about the easiest motor on the face of the planet to work on. Should be straight forward. Just make sure the battery switch is off
 

·
I Love microskiff.com!
Joined
·
611 Posts
Discussion Starter · #3 ·
Its about the easiest motor on the face of the planet to work on. Should be straight forward. Just make sure the battery switch is off
Yep, disconnect battery is step 1 in the manual, 3 bolts and 1 wire. Just did not know if there were any alignment things to watch out for or things like that.

Thanks,
Jim
 

·
> PRO STAFF <
Joined
·
7,524 Posts
Only thing I have to add is check your cables.
Run your hands down the length and feel for distortions or swellings caused by corrosion.
Ensure the terminal rings are clean and and tight to the wires.
Do a resistance check, using an ohm meter, to determine if any corrosion problems have occurred internally.
 
1 - 4 of 4 Posts
Top