Dedicated To The Smallest Of Skiffs banner

some pictures of my work

3911 15
torn off pulpit...



1 - 16 of 16 Posts

· don't let common sense get in your way
Joined
·
462 Posts
Discussion Starter · #4 ·
cutting up a deck - to repalce a fuel system







this was a wellcraft 240 - it didn't have access to the tank - the deck required cutting,and glassing back down...
 

· don't let common sense get in your way
Joined
·
462 Posts
Discussion Starter · #8 ·
some of the products i make:

hull vents



these are fiberglass -recessed


electronics boxes/helm pods









mfg various other products,including custom spray rails...
 

· Cert. Yamaha technician
Joined
·
4,360 Posts
Kreepa, wurst has a good point believe it or not..
My father was a lifelong boat builder for a living. Several years after retiring (he got lucky and sold his shop in the late 90's), he got bored and wanted to work again, but not hard, just enough to keep his mind busy. Well somehow he got into repairing blisters in spas and hot tubs.. He made a friggin killing, and only worked a couple hours a day at his own pace (disabled vet). When i was younger he would take me to help him, we would gring a couple blisters, fill em, and re paint /match that marbelene color and make $800 a day. And be done.. It was friggin cake ;D
 
1 - 16 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top