Dedicated To The Smallest Of Skiffs banner
1 - 2 of 2 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 ·
So the screw that holds/clamps the oblong control "box" to the shaft somehow fell out and now it spins freely on the shaft, therefore, I can't control the direction of thrust. Any ideas what size hardware I can get at Ace to use as a replacement screw?  I'll try to get a pic if its un-clear what I'm talking about.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top