Dedicated To The Smallest Of Skiffs banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,282 Posts
I feel you pain. The Whipray I bought had one and I remove it myself, which wasn't hard, but messy. But then to sell it, all parts were under warranty and a bit corroded or cracking, so they sent me a rebuild kit. I won't do that again.

But I did have my glass guy plug the holes and refinish - cannot even tell it was there. I was going to bolt and caulk, but it wasn't too expensive to plug, plus the boat needed to be wet sanded, buffed and then I had ceramic coating applied. Hull came out looking brand new.

Good luck - and I do like the ideas of making a plate. I have a push stake that I had hope could be mounted in the same holes, but I went with an engine mount instead.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top