Dedicated To The Smallest Of Skiffs banner
1 - 3 of 3 Posts

·
Registered
Joined
·
167 Posts
Discussion Starter · #1 ·
Im starting to redo the transom on my 13 and have a couple pieces of coosa to use. My plan is to use fasco 110 to attach the coosa to the transom skin. Should I laminate the coosa on both sides then fasco it or can I fasco it to transom and lay glass once its adhered? My thoughts are that if i just fasco and then lam it i wont have to worry about any delamination from my poor workmanship:)
 

·
Registered
Joined
·
167 Posts
Discussion Starter · #4 ·
I already have a gallon kit of the 110. I assumed it was mixed to a putty consistency and it would not work into cloth very well. I'm also adding a section over the ankle breaker. Are you saying ditch the fasco and use something like 105? I have some cabosil so I could make a putty for adhesion...
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top