Dedicated To The Smallest Of Skiffs banner

IPB 14 with 4 blade

1462 Views 3 Replies 3 Participants Last post by  flatout87
I'm going to be picking up an IPB 14 in the next few days, and I have plans to put a jack plate and 4 blade prop on it. The engine that I'll be putting on it is a 2002 25hp merc 2 stroke. Any suggestions or anyone running a 4 blade on their IPB 14. I'm sure ya'll have more knowledge about props and pitch than I do.
1 - 1 of 1 Posts

· Living & Dying in 3/4 Time
Joined
·
2,596 Posts
Agreed, with that boat & motor combo I don't see a need for a 4 blade. If you're trying to run ultra skinny you'll need tabs & a jack plate too.

I always recommend starting with Turning Point aluminum propellers. They already have a good amount of cup built in and are surprisingly affordable.  A 10x13 should be a good starting point and I'd expect a little over 30mph with your setup and still jump on plane.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top