Dedicated To The Smallest Of Skiffs banner
1 - 1 of 1 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 ·
Working on old motors that need a little help: an '84 6Hp Johnson and an '89 15Hp Evinrude.

a. I don't have the original fuel lines for either of them. How do I find out for sure that I'm purchasing the right diameter? I'm assuming 3/8 is about right for both. Is it critical to get that right?

b. The fuel in my tank has been sitting there for several months. The first thing I want to do is throw it out and start fresh, to eliminate that variable during troubleshooting. Where/ how can I dispose of it easily, safely, and legally? It is an oil/ gas mix.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top