Dedicated To The Smallest Of Skiffs banner

1 - 4 of 4 Posts

·
I Love microskiff.com!
Joined
·
73 Posts
Discussion Starter #1
First off, please excuse my lack of knowledge of props.

I have a '08 40hp E-Tec tiller that has a 13.25x17 prop, this is the stock prop. I am interested in a stainless 4 blade prop for sale on this forum but, it is a 13x17. Would this prop work? I believe it would just have a quarter inch smaller diameter but I am not that familiar with props other than they spin and make the boat go:) Thank you in advance for your help, Boney

Tight Lines!
 

·
I Love microskiff.com!
Joined
·
73 Posts
Discussion Starter #3
I'm not sure because I don't have any guages, but a friend of mine running the same motor says his at WOT runs about 5600-5700

Tight Lines!
 

·
Registered
Joined
·
1,544 Posts
Typically when moving from a 3 blade to a 4blade your RPM’s will drop and you will need to go to a lower pitch, also you need to make sure it has the right splines for your engine.
 
1 - 4 of 4 Posts
Top