Dedicated To The Smallest Of Skiffs banner
1 - 7 of 7 Posts

I Love!
2,633 Posts
Discussion Starter · #1 ·
I have a few pieces of 3/16 and 5/32 epoxy carbon fiber plates cut from a 12"x12" and 12"x 24" plate that would be good for re-enforcement or fastener plates in Conchfish skiff builds. I used two pieces to replace the top plates on Shaw wing cavitation plates. The small plate cost $125 large plate was $160 from Hillside Composites. Asking $15 for each small piece and $30 for the large plate.



1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.