Dedicated To The Smallest Of Skiffs banner
1 - 1 of 1 Posts

Won "Do More With Less" Award!
1,771 Posts
Discussion Starter · #1 ·
I have a bob's 4” ultralite hydraulic jackplate rated for 115hp.

I just rewired the relay switches and to the 12 volt battery. Then I got it working just fine until it's stop working. So I make sure all is connected tight with hydraulic pump and relay switches......then still nothing. Until I bypass the wire to the relay switches then it's working from going up and down. Then I connected the wires back again like it was then it was working then I stop hot wire it. 5 mins later......I try again......still,nothing! I just got fed up messing with it.

Anybody can help me out on this one? :mad:
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.