Dedicated To The Smallest Of Skiffs banner

1 - 7 of 7 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
I have a couple small holes on the side of my aluminum Jon boat. What types or brands of sealant do y’all recommend to seal those with?
 

·
Registered
Joined
·
3,277 Posts
Pin hole, bullet hole? Recently seen 2 riveted aluminum boats fixed with 5200 “type” and both are peeling off. And smearing it over area was probably not the best approach. Maybe a two part epoxy
 

·
I Love microskiff.com!
Joined
·
142 Posts
I used JB Weld stick epoxy, the holes were above the waterline, 1/4" screw/bolt holes. It worked well, filled sanded filled sanded.
 

·
I Love microskiff.com!
Joined
·
1,321 Posts
You can buy an epoxy stick with aluminum powder in it. Surface prep is everything.
 
1 - 7 of 7 Posts
Top