SOLD/EXPIRED 2013 Shadowcast - Guide Green Monochrome

Discussion in 'Sold/Expired Classifieds' started by el9surf, Jul 3, 2013.

  1. el9surf

    el9surf Well-Known Member

    3,349
    943
    1,968
    2013 Shadowcast 16 - Guide Green Monochrome

    Here is the chance to skip the 5+ month wait on a new sc 16 build.
    This boat has been garage kept and meticulously maintained since day 1. You are getting a turn key package with an almost new 2 stroke that can easily be converted to a 30 HP.

    -Custom glassed in rod racks 4 spinning rods, 2 fly rods and anchor pin storage w/ sea deck   
      gunnels & bungee tension cords
    -Waterproof front hatch w/ stainless latch
    -8 gallon bow mount aluminum fuel cell
    -Flush Mount Marinco Trolling motor deck mount plug
    -Complete Trolling Motor Pre Wire
    -Male end of Minn Kota Quick Release bracket
    -Pop up Stainless cleat
    -Lenco Trim tabs 9 x 9
    -Trim tab switch mounted on rear bulkhead
    -4 outlet waterproof switch panel
    -In line fuel water separator
    -2 chase tubes connecting front and rear compartments, one at base of each gunnel
    -Small AGM battery Runs switch panel and trim tabs
    -Deep Cycle Excide Group 24 TM battery
    -Waterproof Master Breaker Switch Panel
    -Rhule Bilge pump manual switch
    -Poling platform w/ rod holder welded in place,  all powder coated black
    -Bow Mount Platform – Powdercoated to match
    -Tibor push pole holder
    -Stiffy deck mount push pole holders

    2012 Mercury Sea Pro 25/30 2 stroke / Purchased brand new out of box 7/2012
    Commercial Grade Dry weight 105 lbs
    http://www.mercury-marine.eu/mercury/en/Products/Products.aspx?Model=SeaPro 25
    Will not seperate from package at this time.
    -34 hours total - Motor flushed with fresh water and salt away after every use. 
    -Tiny Tach
    -Carbon Marine – Carbon Fiber Tiller Extension
    -Stock Aluminum Prop
    -Your choice of 3 or 4 blade Powertech SRA Stainless prop.

    2013 Custom Float On Aluminum Trailer w/stainless steel bolt package – Torsion Axle, LED Lights, ---Swing Tongue, Guide on Bunks, Grease fitting on hubs, spare wheel / tire and full hub assembly
    -Garage fit w/ swing tongue – LOA approx 18'5" total

    Asking $11,000 - Please call Eric at (407) 257-9074 or pm me with questions. Located in North Orlando

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]
     
  2. anytide

    anytide Administrator Staff Member

    4,129
    532
    1,968
    now thats a deal !!!!
    GLWS
    :)
     

  3. cullennn

    cullennn Clamshavin'

    137
    0
    341
    Awesome skiff!!!! This one will go quick
     
  4. Jestevez

    Jestevez I Love microskiff.com!

    61
    0
    81
    Nice skiff! Why are you selling it?
     
  5. Never seen one with tubes going into the front hatch what's that all about
     
  6. el9surf

    el9surf Well-Known Member

    3,349
    943
    1,968
    Had Mel build custom integrated racks to accomodate more rods, they stagger going forward and backward.. Also has anchor pin storage.

    Getting to a point where I need something that will accomodate my family of 4 otherwise I wouldn't be selling. As a 2 person fishing skiff this boat will get into the tightest spots and float and run in spit.
     
  7. jonterr

    jonterr I Love microskiff.com!

    556
    77
    153
    Im glad to see someone using the sea pro! I've got one on my skiff and love it! I bet that thing gets skinny!
     
  8. el9surf

    el9surf Well-Known Member

    3,349
    943
    1,968
    The sea pro is a fantastic motor. Reliable, strong, lightweight and a perfect fit on the sc. The motor still has almost all of the factory paint on the skeg. A testament to its ability to run skinny and the fact that it is still basically new.
    I will try to post a couple updated pictures showing the prop and bow casting platform.
     
  9. el9surf

    el9surf Well-Known Member

    3,349
    943
    1,968
    Bump for an immaculate sc in almost new condition.

    I am willing to sell the boat and trailer as a package without motor if you already have a motor to put on the boat. I will not sell the motor or any other components before the boat and trailer are gone.

    I'm also willing to add or deduct components such as trim tabs, bow casting platform, ss prop, tibor pole holder, wang anchor pin holder, batteries... to help fit a budget. If you want the I pilot 55 lb tm it can be added for a fee.

    If you are interested in this specific boat please feel free to contact me, I'm flexible and happy to try and work something out for a fellow microskiffer.
     
  10. el9surf

    el9surf Well-Known Member

    3,349
    943
    1,968
    Bump for a sc less than 14k. I will have some new photos up this weekend. Lots of interest so far.
     
  11. waltonleddy

    waltonleddy I Love microskiff.com!

    34
    0
    81
    my dream boat. if this was 3.5k less it would probably be in my driveway. sick skiff man. exactly the way i would build one.
     
  12. el9surf

    el9surf Well-Known Member

    3,349
    943
    1,968
    I have had several questions on this. Ankona can add a glassed in guide box if desired that is color matched.

    I kept the center area open to keep the cockpit clutter down. When I fish alone or duck hunt its nice to have the open cockpit.

    Almost forgot I have a custom built camo cover I made that covers the entire boat. Included in the price.
     
  13. tyler0421

    tyler0421 I Love microskiff.com!

    66
    2
    333
    Do you have a picture of your camo cover?
     
  14. el9surf

    el9surf Well-Known Member

    3,349
    943
    1,968
    I will have to take a picture of it when I get some time. Its made of a camo cloth that is spliced together with glue and zip ties. It basically fits on like an outdoor cover.
     
  15. el9surf

    el9surf Well-Known Member

    3,349
    943
    1,968
    Took some more pics today, will post later tonight.
    Bump to the top
     
  16. el9surf

    el9surf Well-Known Member

    3,349
    943
    1,968
    Here are some taken yesterday. Bump for a new week.
    Just a note the lid on the bow platform can be color matched. Just haven't had time to mail it off to Ankona to have them do it yet. It still works though  ;)

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]
     
  17. el9surf

    el9surf Well-Known Member

    3,349
    943
    1,968
  18. mikeregas

    mikeregas I Love microskiff.com!

    543
    0
    141
    Interested in selling the push pole?
     
  19. el9surf

    el9surf Well-Known Member

    3,349
    943
    1,968
    No not selling the push pole.
     
  20. el9surf

    el9surf Well-Known Member

    3,349
    943
    1,968
    As mentioned before I will happily sell the hull and trailer as a package without the motor. Wouldn't mind keeping the motor. It would include everything listed except the motor, tiller extension and props. Again I will not sell the motor individually before the hull and trailer are gone.

    Pm me if interested.

    Also for those expecting me to drop the price 2- 3 grand quit wasting my time.
    Go get in line, wait till December and see how much it cost to build a new one.