Clean and zero issues. Loaded with all the goodies. Power pole, trim tabs, tibor push pole holder, stiffy hybrid push pole, simrad evo3 7”, iPilot 24v trolling motor with custom shaft, ranger cover and motor cover included. 147hrs on Evinrude ETEC. Full service in June. Washed and flushed after...

SOLD PLEASE REMOVE LISTING • 2019 Skimmer Skiff 16'6" • 2018 Tohatsu 50hp ~300 hours (With 2 years of transferrable warranty) • Seafoam/Teal hull, two tone white/teal deck • 3 Blade Stainless Powertech Prop – 14 pitch • 6 Foot Powerpole Pro Series II – starboard side • 55 lb thrust Haswing...

Unfortunately the time has come to sell our skiff. We ordered this skiff from Kevin at East Cape in 2014 and have enjoyed fishing over the years. We have it listed and at Rockport Marine by Cove harbor and it is available for showings. Please contact Jeff at 361-729-7820 Highlights 2014 Etec...

So I'm drawing up the plans for a 16' wood flats skiff. I the majority of the time someone will be poling in the aft, while another is fly fishing in the front. I can't think of a good casting deck material, short of plywood (which doesnt fit the theme of the build; classy) or planing down some...

I was trying to take a 14ft boat I found and turn it in to a poling skiff, it is a tri hull fiberglass boat, just wanted to know if it would be worth doing of if it’s the wrong hull?

Hey y'all, I am currently in the process of trying to sell my 13' Gheenoe for a larger craft that is more comfortable for my wife to ride in so she'll actually look forward to taking the boat out. I live in Charleston and primarily fly fish flats FWIW. I have been looking at the Skimmer Skiff...

$16,000 Orlando, Fl [email protected] 407-four five six- 2869 2012 Ankona Native SUV 17 2012 Float On Aluminum trailer 2011 Tohatsu TLDI 40hp Lenco trim tabs BayStar Hydraulic Steering 6’ Signature Series Power Pole Dual Pro Recreation Series Twin Battery onboard charger Hummingbird...

Decided to list my 2016 Ankona shadowcast 16’. I want to start off by saying i have literally taken out every inch of wire in the boat and run all new marine wire and duplex to everything on a new fuse block and switch panel. The boat needs nothing at all and is ready to fish right now and im...

2007 East cape gman 2018 20hp yamaha serviced religiously < 100 hours Minnkota trolling motor w/ new battery (full speed like 10 mph LOL) Cabin lights NAV lights Rear storage Poling platform Spray rails, completely dry ride Poles in 4 inches with 2 200lb people Hull weight <350 lbs, beam 38" in...

My son is looking to sell his 14' Center Console Poling Skiff and buy a larger used 2008 Ultra Cat Majek bay boat. Does anyone know if Majek uses wood in the construction of their boats? I cannot get an answer from Majek. Also, any tips on how to tell if the hull is comprimised would be...

Selling my poling skiff. It breaks my heart because it’s such an awesome boat for this area, I just need more room for the family and to be able to bring friends and our dogs. 2002 Mitzi 16 ST with 2002 Nissan 50 on a 2009 coastline trailer. Boat has flats jack jack plate, lenco trim tabs...

2002 Mitzi tiller with 2002 Yamaha 40 hp 2 stroke. Texall Aluminum trailer 3 years old. Trailer will be fine for haul back to Florida. Bob's manual jackplate. Nedski foil. 2 props. 18' stiffy hybrid push pole. Carbon Marine tiller. Hours unknown. Mix oil in gas. Never had carb problem. These are...

Where my flats gurus at? I'm wildly inexperienced when it comes to fishing the flats, but I hear the fish calling... For most of my life I've had the fortune of an old timer sitting in my corner showing me tips & tricks he's picked up over the last 60 years, but the flats are as much out of...

Selling a 2005 Beavertail Skiff Boat is equipped with a 2005 Mercury 40hp 2-stroke with under 500hours Aluminum trailer with torsion axle and removable tongue (less than a year old on axle etc), spare tire and mount and additional bearings, tires have plenty of life. Trailer set up for dry...

I find myself fishing alone quite a bit and trying to pole my skiff off the stern platform sinks it too much to get a good draft without someone on the bow. I have been poling on the bow, basically backwards till I can spot something then spin it around 180 (if it's wide enough) and try to cast...

The boat is in very good shape and so is the trailer. The motor is a 2011 90hp Yamaha 2 stroke that was hung on the boat new in 2014 very low hours. Has bow casting platform, trim tabs, live well and custom spray rails installed professionally. never kept in the water always on a trailer on...

Selling my extremely clean, garage kept 2014 16’ Inshore Power Boat (IPB). Boat was built by Bonefish Boatworks, you can look up the build album on their page under the name “****** Bulger”. Only selling the boat to upgrade for the family. The boat is perfect for the flats and floats in spit...

2018 hells bay marquesa 65000.00 2018 model year yamaha 115 sho with 29 hours 2018 ram lin trailer with spare 30 gallon fuel tank 18' 1"length 79" beam hull color-albury bro. sky deck and non skid -matterhorn white atlas hydraulic jackplate poling tower tab mounted with step and backrest and...

I have a 2018 Beavertail Mosquito for sale. New baby due March 20th and I need it gone. Has under 20hrs on it and looks brand new. Has DF60, all the standard options + side console and several extras. Give me a call at 352-284-9574 if you have any questions. The boat is stored in SE Houston...

sold...thanks