Dedicated To The Smallest Of Skiffs banner

jackplate

  1. Lt25 jackplate question

    General Discussion
    I know this probably has been discussed quite a few times but I searched the forum and couldn't find an answer. I have a Suzuki DF20a on my LT25. Currently most of the weight is in the back of the boat, including me, Vance jackplate, gas tank, and a freshly installed rear deck and hatch. The...
  2. Sponsons, without a tunnel....good or bad? Compression plate, same ??

    General Discussion
    I have a 1756 Lowe VT tinny. It has a manual Jackplate. Runs fine but I'd like to go skinnier. Can I raise the engine even more if I add sponsons? Can I raise the engine even more if I add a compression plate? What if I add both? Looking for answers from owners who have added one or...
  3. Customized 15'4" gheenoe for sale

    Microskiffs For Sale
    - 2003 15'4" gheenoe with middle box removed and front deck added - 2011 continental trailer with recently installed LED lights - 2015 4 stroke 9.9hp mercury - 3 gallon fuel tank - push pole holders I am original owner for boat motor and trailer, have receipts for all three as well as title in...
  4. Question about 20hp yamaha

    General Discussion
    hey everyone, i have a 2012 yamaha 4 stroke 20 hp with tiller that I'd like to put on my boat. I currently have a 25hp 2 stroke merc that works with my atlas micro jack plate. Will my clamp on 20hp fit on the atlas micro? Can I get a tilt/trim for it that works with the jack plate? Lastly how...
  5. Gheenoe Classic

    Microskiffs For Sale
    Taking the ad down
Top