Dedicated To The Smallest Of Skiffs banner

2014 Hells Bay Waterman 18, Yamaha F70, RamLin

17K views 35 replies 19 participants last post by  Matts 
#1 · (Edited)
2014 Hell’s Bay Boatworks Waterman 18 side console. Ice Blue Top, Matterhorn White Bottom, keel guard, 3 bank battery charger for 24V TM setup, console extension with cup holder, hook pull, Tibor PP holder, 12V convenience outlet, running livewell with bubbler, two clamp-on rod holders, LED lights and gas shocks everywhere.
2014 Yamaha F70 currently has 516 hours and new Powertech SCD3R15PYM90 stainless steel prop.
2014 RamLin Deluxe Aluminum Trailer (stainless steel cross members, LED Lights & removable tongue)
2016 MinnKota iPilot 24V 80# 54"
2017 Simrad GO9 XSE with HDI skimmer transducer
Deluxe Custom Fitted Boat Cover
Custom one piece flip-flop seat cushion
Custom bolt on Pro Trim size casting platform
Custom Poling Platform sissy bar with stripping bucket holder.
Gray SeaDek on platforms and reel pads.

Registered in Georgia, Garage kept in Crystal River, Florida

Sale Pending

Vehicle Boat Speedboat Watercraft Boat trailer
Vehicle Machine Skiff
Vehicle Automotive wheel system Wheel Car
Vehicle Boat Bass boat Speedboat Trailer
Pedometer Technology Electronic device Measuring instrument Auto part
 
See less See more
5
#11 ·
Just had HB: repair the bow keel area from beach wear and install a keel guard; take the jackplate off and remount the engine with fresh bolts and sealant; move the USCG rating placard over so the raised lettering on it doesn't scuff the flip-flop seat cover when you tuck it under the cap; repair one spot on the cap that had an air bubble under warranty; replace the trailer bunk swivels that were galvanized with aluminum swivels and SS screws; and replace the sticker on the right side of the trailer where one of the letters had come off.

I have also replaced the 1500# rated Dexter drop center torsion axle that had worn out with a 2200# Dexter torsion axle, and added a bow roller that keeps the boat from moving when pushing it around while the tongue is removed. Much easier to put the tongue back in, and adds hull support for the bow of the boat.
 
This post has been deleted
#26 ·
What brand/ kind of keel roller did you install? Sometimes when I use a certain ramp that is steep I have trouble finding the right spot with the trailer in the water. if too low in the water the bow will be under the roller at the winch so I have to go back to the truck and pull up some. Feel that this would help with that. Beautiful skiff and GLWS. Whoever makes this purchase will not regret it! haha and Pangas, bachelors in depreciation, "half that price"...... Give me a break.
 
You have insufficient privileges to reply here.
Top